Mv /etc/apt// /etc/apt//turnkey-testing.list If you're open to assist me to push this forward, please enable the relevant testing repo on your TurnKey appliance and install the newer packages. As I'm currently juggling lots of priorities, lack of feedback meant that it slipped down my list. But seeing as it doesn't appear critical, I figured it better to err on the side of caution. If the CVEs affected our default config/setup, then I may have pushed them anyway. I have tested them briefly myself, but experience has shown that that is rarely sufficient. But unfortunately, despite the interest, no one has given any feedback yet! Strictly speaking if the upgrade breaks Webmin (even if it fails to restart cleanly) that is considered a "DoS" (denial of service) so could be considered a security bug in and of itself. My intention was to move them to the main repos once I had some feedback to confirm that the upgrade didn't break anything (it shouldn't but seeing as the CVEs don't affect default config, being a bit more cautious seemed wise). Following some discussion on Reddit, a few weeks ago I uploaded new Webmin (v2.000) packages to both our "buster-testing" and "bullseye-testing" repos. Regardless, I do really hope to resolve this properly ASAP. Having said that, it should only be an issue if you have granted a malicious actor a log in. However, you are also right that some custom user configs/setups may make it vulnerable. assuming that you use default config), none of the vulnerabilities should affect TurnKey's packaged Webmin. You are right that there are unpatched CVEs against the version(s) of Webmin that we currently provide. I'm a bit under the pump at the moment trying to get the v17.x release finalised (after a range of other issues that have diverted my attention). If you are still unable to get into the Virtualmin control panel at this time, we recommend you reboot your VPS service via the Xen virtual shell.Hi Chris, deep apologies on my slow response. When prompted, enter your root username and password. Once your command window returns to the command prompt, try logging into your Virtualmin control panel again at, replacing clientlogin with the login name you chose when you signed up.On the command line, type the command /etc/init.d/webmin start and press Enter.Note that you may get an error message that says the Webmin service is already stopped. On the command line, type the command /etc/init.d/webmin stop and press Enter.You will need to log in as the root user in order to run the restart command. Since Virtualmin is a subcomponent of Webmin, you must restart Webmin in order to restart Virtualmin. For more information, please visit the official Webmin and Virtualmin documentation. Virtualmin is a module that works with Webmin to host and manage multiple websites on a single server. Webmin allows Cruzio VPS customers to manage their VPS service via a graphical point-and-click interface, rather than the command line. Overviewīy default, Cruzio installs two major web-based control panels on each VPS service: Webmin and Virtualmin. If you are unable to reach your Virtualmin control panel and unable to connect to your VPS service via SSH, you will not be able to run the commands supplied in this article, and should reboot your VPS service via the Xen virtual shell. These instructions assume you have Cruzio VPS service and are able to connect to your VPS service via SSH. This article is designed to help Cruzio VPS customers who are unable to reach their Virtualmin control panel at, where clientlogin is the login name you chose when you signed up.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |